Colour Wheel; Gobo Wheel; Shutter / Strobo; Effect Wheel - Futurelight Scan SC - 530 Mode D'emploi

delay. If the lamp is damaged or if the inside temperature is too high (can be occurred if the ambient temperature
is 55°C or more) the switching On the lamp is unsuccessful and the message "HEAt" will appear on the control
board display. After 5 minutes the fixture's software will try to start the lamp again and if this is five times unsuccessful,
on the display will appear "LA.Er", meaning that the lamp could be damaged or even missed, the fixture is
overheating or there could be a failure on the transformer

6.3 Colour wheel

The SC-530/570 has one colour wheel with 12 color positions - 11 of these with dichroic colors and the last one
open. The wheel can be positioned between two adjacent colors in any position. It is also possible to rotate the
color wheel continuously at different speed „Rainbow effect".

6.4 Gobo wheel

This wheel has 8 metal gobos + 1 multicolor dichroic gobos + open position, metal gobos are interchangeable.
Multicolor dichroic gobo (containing C,M,Y colors) is mixable with color wheel especially with cyan, magenta and
yellow colours in order to obtain several different multicolor beams.

6.5 Shutter / Strobo

The shutter unit is situated on the gobo wheel and it enables to produce strobo effect from 1 to 7 flashes per
seconds.

6.6 Effect wheel

This wheel has both hot and cold color temperature filters (3200 and 5600°K). Total numbers of color combinations
are 36.

6.7 Dimmer / Wash light

0 - 100% smooth dimming and the wash light is provided by the special effect wheel.

6.8 3-facet Prism

3-facet prism rotating in both directions at different speed is situated at the special effect wheel.

6.9 Fan

The SC-530/570 is cooled by axial fan situated at the rear side of the lighting. The speed of the fan (of course the
noice) can be continuously reduced if very quiet performance is required. Low fan speed reduces the cooling of
the lighting, but if the temperature inside increases about certain level, the fan automatically raises its speed in
order to control inside temperature of the lighting. This cycle can repeat several times until the temperature
inside is on suitable level.

7. The SC-530/570 Control Board

The control board situated on the top side of the SC-530/570 offers several features. You can simply set the
lighting address, read the number of lamp or unit hours, switch On and Off the lamp, run test show, make a reset
and also use special functions for manual, demo and service purposes.
The main menu is accessed by pressing the [Mode] key - press this one so many times until the display shows
message "A001" (with actually stored address). Browse through the menu by the pressing [Up] and [Down]
keys - the display shows step by step these messages: "A001, rPAn, rTilt, 16br, Lati, Poti, LAMP, tESt, rESE,
SPEC". Press [Enter] if you wish to select one of them. The functions provided are described in the following
sections and the function hierarchy is shown below.

7.1 Main functions

- DMX 512 Address settings
The letter "A" flashes. Use the [Up] and [down] keys to select required address (001 - 496) and press [Enter]
to confirm or [Mode] to cancel and return to the main menu.
- Pan reverse
This function allows you to invert the pan movement. Use the [Up] and [Down] keys to select "On" if you wish
this feature or "Off" if you don't wish this feature and press [Enter] to confirm or [Mode] to cancel and return to
the main menu.
2 6