Futurelight Scan SC - 530 Mode D'emploi page 29

- continuous controlling of the fan speed
the fan automatically raises its speed in order to control inside temperature of the lighting,
if the temperature inside increases about certain level (the low fan speed reduces the cooling of
the lighting). This cycle can repeat several times until the temperature inside is on suitable level.
- low/high speed of the fan operating
the fan keeps the adjusted low speed until the temperature exceeds max. inside temp..of the
fixture, then the SC-530/570 automatically switch from low to high the fan speed.
- low speed / Switch Off the lamp operating
the fan keeps the adjusted low speed until the temperature exceeds max. inside temp.. then the
SC-530/570 automatically switch Off the lamp.
- Adjusting the default positions of colour, gobo and effect wheels
By this function you can calibrate and adjust the colour, gobo and effect wheels to their standard/right positions.
Use the [Up] and [Down] keys to browse through the adjusting menu - the display shows step by step these
messages: "PAn, Tilt, SPEd, Col, Sgob, EFEC, rotP" by which you can adjust the fixture to the required /
desired position (0-255) before the function calibration. Then when the positioning is finished use the last
"FCAL" function (Fixture calibration).
1. Calibration via the control board
Press [Enter] and on the display will apper by using [Up] and [Down] keys these messages: "Col, Sgob,
EFEC" for their very smooth function calibration. Select one of them press [Enter] and use the [Up] and [Down]
keys in order to adjust their right value from 0-255 Then press [Enter] to confirm or [Mode] to cancel and return
to the menu. This can be repeated for each calibration parametr if it is required. When the calibration works are
finished it is necessary to use the "ArES" function in order to write the calibration values to the memory
(EEPROM) and to make a reset in order to check the new adjusted positions of the colour, gobo and effect
wheels. When the reset of the fixture is finished on the display will appear the "FCAL" message. Press [Enter]
to repeat the calibration or [Mode] to return to the "AdJ" menu.
2. Calibration via the external controller
Press [Enter] and on the display will apper by using [Up] and [Down] keys these messages: "Col, Sgob,
EFEC" - calibration parameters. Select one of them and press [Enter].
Now you can calibrate the colour, gobo and effect wheel by your controller. The DMX calibration protocol is
described in the table mentioned below.
DMX Calibration protocol:
After having calibrated required functions press [Enter] to confirm (or [Mode] to cancel and return to the menu
without reset by the "ArES" function) and use the "ArES" function in order to write the calibration values to the
memory (EEPROM) and to make a reset in order to check the new adjusted positions of the colour, gobo and
effect wheels.
2 9