Error Messages - Futurelight PHS-750E Mode D'emploi

Example:
Program 2 includes scenes: 10, 11, 12, 13;
Program 4 includes scenes: 8, 9, 10 and
Program 6 includes scenes: 12, 13, 14, 15, 16
Auto Pro Part 1 is Program 2;
Auto Pro Part 2 is Program 3;
Auto Pro Part 3 is Program 6
The 3 Slave groups run the Auto Program in certain time segments, as shown in the following picture:

Error Messages

When you turn on the fixture, it will make a reset first. The display may show an error message while
there are problems with one or more channels. The error message stands for the channels equipped
with a testing sensor.
For example, when the display shows "Color Wheel", it means there is some error in the color wheel
channel. If there are some errors on several channels at the same time, you may see the error
messages flash repeatly for 5 times, and then the fixture will generate a reset signal, all the stepper
motors will reset. If the error messages maintain after performing reset more than 3 times, it will
detect whether the fixture has more than 3 errors. If the fixture has more than 3 errors (including 3
errors), all the channels can not work properly; but if the fixture has less than 3 errors, only the
channels which have errors can not work properly, others can work as usual.
The respective error message will appear after the reset of the fixture if the channels magnetic-indexing
circuit malfunction (sensor failed or magnet missing) or the stepping-motor is defective (or its driving IC on
the main PCB). The channel feature is not located in the default position after the reset.
The different error messages are:
PAN Moving
TILT Moving
COLOR Wheel
Cyan COLOR
Magenta COLOR
Yellow COLOR
CTO COLOR
Rotation GOBO 1
GOBO Rotation 1
Rotation GOBO 2
GOBO Rotation 2
Prism
Focus error
Stepless zoom
Strobe
61/120
Iris
Fire wheel
00024321.DOC, Version 1.4