Télécharger Imprimer la page

Maytag PERFORMANCE Serie Guide D'utilisation Et D'entretien page 22

Publicité

Les langues disponibles

Les langues disponibles

Begin procedure
1. Open the washer door and remove any clothing or items from the washer.
2.
Using the AEERESH 1Mwasher cleaner (Recommended):
Add one AFFRESHr_ washer cleaner tablet to the washer drum.
3.
4.
5.
If using liquid chlorine
bleach:
Open
the dispenser
drawer
and immediately
add 2/s cup (160 ml.) of liquid
chlorine
bleach
to the bleach
compartment.
NOTE:
Do not add any detergent
to this cycle. Use of more than 2/3 cup (160 ml.)
of bleach
will cause product
damage
over time.
Close the washer
door and dispenser
drawer.
Select the Clean Washer
cycle.
Press START/PAUSE.
NOTE: The basket will rotate, then the door will
unlock,
lock again, and then the cycle
will
continue.
The machine
will bring
in some inlet water, and the basket will rotate while
the
washer
runs a short sensing cycle. This will take approximately
3 minutes.
6.
The cycle will determine
whether
clothing
or other items are in the washer.
a)
b)
If no items are detected
in the washeb
it will proceed
to
Step 7.
If any items are detected
in the washeb
"rl." will
be
displayed,
and the WASH
and CONTROI_S
I_OCKED lights
will remain
[it. The door will unlock.
Open
and remove
any
garments
in the wash drum.
Press POWER/CANCEl.
to cancel the failure code. Then
repeat steps 3, 4, and 5 to start the cycle again.
7.
Once the cycle has begun,
allow
the cycle to complete.
8.
After the cycle is complete,
leave the door open slightly
to allow for better ventilation
and
drying of the washer
interior.
Always
do the following
to maintain
washer
freshness
Use only HE High
Efficiency
detergent
I.eave the door slightly
open after each cycle to allow
for better ventilation
and drying
of washer
interior.
Repeat the cleaning
procedure
monthly
or when the CI.EAN WASHER
REMINDER
light
illuminates.
If you are not ready to run the Clean Washer
cycle, but the Clean Washer
Reminder
light
is illuminated,
press the Clean Washer
Reset button.
If the procedure
does not sufficiently
improve
the machine
freshness,
evaluate
your
installation
and usage conditions
for other causes.
Cleaning
the
Dispenser
Drawer
The dispenser
drawer
is removable
for easy cleaning.
1.
Open
the dispenser
drawer.
Unlock
the dispenser
drawer
by pressing the Release I.ever
in the Oxi/co[or-safe
bleach
compartment.
Remove the drawer.
2.
Wash the dispenser
under running
water to dean.
Allow
to dry.
3.
Return the dispenser
to drawer.
Cleaning
the exterior
Use a soft damp cloth or sponge to wipe
up any spills. Occasionally
wipe
the outside
of your
washer
to keep it looking
new. Use mild soap and water. Do not use abrasive
products.
l tei ¸ Hoses
Replace inlet hoses after 5 years of use to reduce
the risk of hose failure.
Periodically
inspect
and replace
inlet hoses if bulges,
kinks, cuts, weab or leaks are found.
When
replacing
your inlet hoses, record the date of replacement.
_i_
¸ C_a_
Install and store your washer
where
it will
not freeze.
Because some water may stay in the
hoses, freezing
can damage your washer.
If storing or moving
your washer
during
freezing
weather;
winterize
it.
Non-use
or vacation
care:
Operate
your washer
only when you are at home.
If you will be on vacation
or not using your
washer
for an extended
period
of time, you should:
Unplug
washer
or disconnect
power.
Turn off the water supply
to the washer.
This helps avoid unintended
flooding
(due to a
water pressure
surge) while
you are away.
Slightly
open
door to provide
ventilation.
To winterize
washer:
1.
Put 1 qt (1 I.) of R.V.-type
antifreeze
in the drum.
2.
Run washer
on a Drain & Spin cycle.
3.
Unplug
washer
or disconnect
power.
4.
Shut off both water faucets.
5.
Disconnect
water inlet hoses from faucets
and drain.

Publicité

loading