Titan MPS750S-2 Manuel D'instructions page 40

Care and maintenance
6. Check the saw chain for possible wear and damages. Replace it with a new one if
required. Experienced user can sharpen a dull saw chain (see section "Saw chain
sharpening" below).
7. Refit the saw chain (14) and the guide bar (13) as described under "Assembly".
Saw chain sharpening
NOTE: Never saw with a blunt chain. The saw chain is blunt if you have to
push the product into the tree and the chips are very small.
1. Have the saw chain (14) sharpened professionally at an authorised service centre
or sharpen the chain yourself by using a proper sharpening kit. Also observe the
sharpening instructions supplied with the sharpening kit.
WARNING! Only sharpen the saw chain yourself if you are trained and have
experience! Use proper tools to sharpen the saw chain!
2. The height difference between the tooth and the ridge is the cutting depth. When
sharpening the saw chain (14) you have to consider the following points (Fig. 41).
• File angle
• Cutting angle
• File position
• Diameter of round file
• File depth
40
3663602627661_MNL_IN_V02.indd 40 3663602627661_MNL_IN_V02.indd 40
Fig. 40
MPS750S-2 / TTPS750
17-03-2023 16:52:53 17-03-2023 16:52:53