Publicité
Les langues disponibles
Les langues disponibles
Safety information
Causes and operator prevention of kickback
Kickback may occur when the nose or tip of the guide bar
touches an object, or when the wood closes in and pinches the
saw chain in the cut.
Tip contact in some cases may cause a sudden reverse reaction,
kicking the guide bar up and back towards the operator.
Pinching the saw chain along the top of the guide bar may push
the guide bar rapidly back towards the operator.
Either of these reactions may cause you to lose control of the
saw which could result in serious personal injury. Do not rely
exclusively upon the safety devices built into your saw. As a
product user, you should take several steps to keep your cutting
jobs free from accident or injury.
Kickback is the result of tool misuse and/or incorrect operating
procedures or conditions and can be avoided by taking proper
precautions as given below:
Maintain a firm grip, with thumbs and fingers encircling
1.
the product handles, with both hands on the saw and
position your body and arm to allow you to resist
kickback forces. Kickback forces can be controlled by
the operator, if proper precautions are taken. Do not let
go of the product.
Do not overreach. This helps prevent unintended tip contact
2.
and enables better control of the product in unexpected
situations.
Only use replacement bars and chains specified by
3.
the manufacturer. Incorrect replacement bars and chains
may cause chain breakage and/or kickback.
10
3663602627661_MNL_IN_V02.indd 10
3663602627661_MNL_IN_V02.indd 10
MPS750S-2 / TTPS750
17-03-2023 16:52:46
17-03-2023 16:52:46
Publicité
