Titan MPS750S-2 Manuel D'instructions page 18

Before you start
Motor unit assembly
1. Place the product (the rear part) and motor unit on a flat stable surface with the side
cover (12) facing upwards.
2. Turn the pre-assembled screw anticlockwise by using the hex key (10), and remove
it together with the nut, keep them on hand. (Fig. 1)
3. Loosen the locking knob (23) by turning it anticlockwise, pull the pole extension (22)
out. Caution as pole may retract quickly. Afterwards tighten the locking knob (23) by
turning it clockwise. (Fig. 2)
18
3663602627661_MNL_IN_V02.indd 18 3663602627661_MNL_IN_V02.indd 18
Fig. 1
2
1
23
Fig. 2
MPS750S-2 / TTPS750
10
The pre-
assembled
screw & nut
3
22
17-03-2023 16:52:48 17-03-2023 16:52:48