Titan MPS750S-2 Manuel D'instructions page 36

Operation
Thin branches
Thin branches can be cut off with one single cut. To prevent the branch from slivering
and buckling the branch should be cut off in several pieces (Fig. 33).
Thick branches
When cutting off larger branches three cuts are necessary.
Fig. 34
1. First cut into the branch from below outside the place where you intend to cut off the
branch. The cut should go from one third to halfway through the branch (Fig. 34).
2. Cut into the branch from the top outside at the same height the branch is sawn from
top (Fig. 35).
3. Last, cut off the stump with one clean cut from top to bottom (Fig. 36).
4. You might want to seal the cut with a suitable compound.
NOTE: Remove the branches lying on the floor regularly to avoid stumbling
hazards. Check the oil level regularly and fill up if necessary. Switch the power
off and disconnect from power source when leaving the product.
36
3663602627661_MNL_IN_V02.indd 36 3663602627661_MNL_IN_V02.indd 36
Fig. 33
Fig. 35
MPS750S-2 / TTPS750
Fig. 36
17-03-2023 16:52:52 17-03-2023 16:52:52