Publicité
Les langues disponibles
Les langues disponibles
Product functions / Operation
Saw chain stop test
NOTE: Perform the following test before operating your product.
1. Hold the gripping surface (9) with the left hand, the rear handle (1) with your right hand.
2. Ensure the saw chain (14) does not come into contact anything when switching on.
3. Release the on/off switch (8) to switch the product off, the saw chain must come
to a stop.
WARNING! If the saw chain shows any signs of moving stop the motor
immediately! Wait for all moving parts to stop! Contact a qualified specialist
to have a check!
General operation
1. Check the product, its power cord and plug as well as accessories for damage before
each use. Do not use the product if it is damaged or shows wear.
2. Double check that accessories or application tools and the guide bar/ saw chain
are properly fixed.
3. Check the chain oil level, refill if necessary.
4. Always hold the product on its handle(s)/gripping surface(s). Keep the handle(s)/
gripping surface(s) dry and clean to ensure safe support.
5. Ensure that the air vents are always unobstructed and clear. Clean them if necessary
with a soft brush. Blocked air vents may lead to overheating and damage the product.
6. Switch the product off immediately if you are disturbed while working by other people
entering the working area. Always let the product come to complete stop before
putting it down.
7. Do not overwork yourself. Take regular breaks to ensure you can concentrate on
the work and have full control over the product.
8. Before switching the product on, check whether it has been assembled correctly
and all the moving parts are running smoothly!
9. While working, ensure that the product does not strike hard objects, as this can
cause damage.
32
3663602627661_MNL_IN_V02.indd 32
3663602627661_MNL_IN_V02.indd 32
MPS750S-2 / TTPS750
17-03-2023 16:52:51
17-03-2023 16:52:51
Publicité
