Titan MPS750S-2 Manuel D'instructions page 26

Before you start
Harness
The harness (29) helps the operator carry this product.
WARNING! Always attach the product to the harness. Do not carry it only
with your hands!
1. Attach the clip (29a) of the harness (29) to the loop (3) on the pole (24) (Fig. 17).
2. Place the harness (29) so that it runs over your right shoulder. The securing clip
must be located at the right hip (Fig.18).
3. Open the clip (29a) to remove the harness from the loop (3).
4. Open the buckle (29b) to quickly release the harness (29).
5. If required, set the loop retainer (4) on a proper position for comfort and easy control.
Loosen the screw and move the loop retainer (4) back and forward along the pole (24).
It's better to locate the loop retainer (4) within the range about 30cm from the gripping
surface (9). After adjustment, re-tighten the screw. (Fig.19)
26
3663602627661_MNL_IN_V02.indd 26 3663602627661_MNL_IN_V02.indd 26
29
29b
29a
3
Fig. 17
4
2
1
Screw
Fig. 19
MPS750S-2 / TTPS750
24 9
3
Fig. 18
17-03-2023 16:52:50 17-03-2023 16:52:50