Titan MPS750S-2 Manuel D'instructions page 27

MPS750S-2 / TTPS750
Connection to the power supply (for UK only)
WARNING! Always use a residual current supply (RCD) protected supply. If an
extension cord is used, make sure the extension cord is specifically designed
for outdoor use and not lighter than H05VV-F or H05RN-F, 2 x 1.0mm
max 75m.
1. Make sure the on/off switch (8) is in its off position.
2. Connect the power plug to a suitable power source.
3. Now your product is ready for use.
Connection to the power supply (not for UK)
For safety reasons the product is equipped with a short power cord (7). Do not connect
the product directly to the power supply using this power cord. A proper extension cord
is required for operation. Observe the technical requirements for this product when
purchasing an extension cord.
WARNING! For your safety, it is required that the plug attached to this product
is always connected to an extension cord! The extension cord must be suitable
for outdoor use with sockets protected against water splashing! Ensure the
extension cord is of the proper size and type for your product (≥ 1.0mm
The extension cord must always be used with the cable strain relief! Do not
use the product without an extension cord connected! Always use a residual
current supply (RCD) protected supply!
1. Make sure the on/off switch (8) is in its off position.
2. Double the extension cord back about a foot from the end, lead the loop through the
hole (6) and hook the loop over the cable strain relief (5), gently tug on the cord to
ensure that it is firmly secured. (Fig. 20, 21).
3663602627661_MNL_IN_V02.indd 27 3663602627661_MNL_IN_V02.indd 27
Fig. 20
Before you start
and
2
)!
2
Fig. 21
17-03-2023 16:52:51 17-03-2023 16:52:51
27