Sabo 102-17H Mode D'emploi page 103

ENG 48
7. TROUBLESHOOTING
PROBLEM LIKELY CAUSE
1. With the key at The protection of the electronic card has
«ON» the dashboard cut in due to:
remains off with no
audible signal. – badly connected battery
– battery terminals crossed
– completely flat battery or eroded bat-
– fuse blown
– bad earthing to the engine or the frame
2. With the key at The protection of the electronic card has
«ON» the dashboard cut in due to:
remains off, but there
is an audible signal. – electronic card wet
– earthed micro-switches
3. With the key on – insufficiently charged battery
«START» the dash- – battery charger fuse blown
board comes on but – badly earthed starter motor
the starter motor does – you are not ready for starting
not runa
4. With the key on – insufficiently charged battery
«START» the starter – faulty fuel supply
motor runs but the
engine does not start
– faulty ignition
5. Starting is difficult – fault in carburation
or the engine runs
erratically
6. Weak engine perfor- – forward speed too high in relation to
mance during cutting
All manuals and user guides at all-guides.com
tery plates
cutting height (☛ 5.4.5)
TROUBLESHOOTING
SOLUTION
Put the key in the «OFF» position and
look for the cause of the problem:
– check connections (☛ 3.4)
– check connections (☛ 3.4)
– recharge battery (☛ 6.2.5)
– replace fuse (10 A) (☛ 6.4.4)
– check connections of black earth leads
Put the key in the «OFF» position and
look for the cause of the problem:
– dry using tepid air
– check connections
– recharge the battery (☛ 6.2.5)
– replace fuse (25 A) (☛ 6.4.4)
– check earth connections
– check that the conditions allowing
starting are met (☛ 5.2.b)
– recharge the battery (☛ 6.2.5)
– check the level in the tank (☛ 5.3.3)
– check the wiring of the fuel open com-
mand
– check fuel filter
– check that spark plug caps are firmly
fitted
– check that the electrodes are clean
and have the correct gap
– clean or replace the air filter
– flush out the float chamber
– empty fuel tank and refill with fresh
fuel
– check and, if necessary, replace fuel
filter
– reduce the forward speed and/or raise
the cutting deck