Publicité
Les langues disponibles
Les langues disponibles
NOTE. STOP CYCLE function: the washing cycle can
be stopped if you push again the cycle pushbutton "B"
(light "C" flashing now) :
to restarting washing cycl push again button "B".
Manuel self-cleaning cycle:
- Ensure that the tank is empty,
- Make sure that the machine is switched off
- Remove the overflowpipe from the tank
- Close the door of the diswasher
- Press button "A" to switch the machine on
- Self-cleaning cycle starts,
- You can stop it after 5 minutes by pushing button
"A" to switch the machine off.
(for Machine with drain pump the tank fills with water
and stops when maximum level is reached: empty the
tank manually and repeat the operation if needed).
WARNING !
dishwasher door during the washing cycle.
In case of accidental opening the cycle stops. If
You close the door, the cycle starts again from
the point where it had stopped.
At the end of the cycle open the door and pull out
the basket.
ACHIEVEMENTS
Any deficiency in the washing process is
apparent when dirty residuals are visible. Any
halos might be caused by an insuffucuent
rinsing: in this case, check that the rinsing jets
are clean and there is a sufficient pressure in the
water distribution network.
In the case that residuals are present, check
that:
• the washing jets are clean
• there is detergent
• the pump suction filter is clean
• the positions of the objects in the rack are
correct.
Adding Rinse Aid and Detergent
CAUTION
: Only use detergent and
rinse aid which are suitable for commercial
washers, a non-foaming industrial alkaline
detergent.
Do not use any soap intended for a residential
dishwasher. This leads to large amounts of foam
building up in the washer and will void your
manufacturers warranty.
CAUTION
: Detergents for commercial
dishwashers cause corrosion. Always follow the
instructions on the packaging and drums.
CAUTION
:
detergent products, this could cause the dosing
pump to break down due to crystallization.
Do
not
open
Do
not
mix
different
CLEANSING AGENTS
Choice of the suitable cleansing agent is an
essential condition if you want to obtain
extremely good washing results as regards
hygienic results. It is then important to consider
some points. First of all only highly alkaline and
chlorine-active antifoam products, especially
made for industrial dish-washing machines,
must be used and they must be produced by
well-known reliable Firms. Mean concentration
of the cleansing agents in powder must be
1,5÷2,5 g/lt. Mean concentration of liquid
cleansing agents must be 2÷4 g/lt.
In order to avoid scales and corrosions, put the
cleansing agent above water level on the
nearest area of the sucking pump filter, in this
the
way it will immediately dilute and will not deposit
on the tank bottom.
NSF 3-2009 requirements for detergent and
chemical sanitizer dispensers
Feeders
OPTIONAL.
When provided see instructions on page 31 in
this manual.
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to
avoid calcareous sediments on glasses and
cups you must add a surfactant on water
(Brightener).
Your cleansing agent supplier will be able to
suggest
machine is equipped with a rinse aid dispenser.
Mean concentration used is 0,15 g/lt.
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump starts up automatically just
during the washing cycle to discharge the
exceeding water coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank, it is necessary
to perform the following operations:
1. Open the door of the dishwasher
2. Remove the overflow pipe from the tank;
3
Afterwards push button "B" for 3 seconds.
(the lamp "H" is lighted).
The discharge will stop automatically after 5
minutes. The control lamp will stop flashing.
Reinstall the flow over and shut the door.
12
(rinse-aid,
or
detergent)
the
most
suitable
are
product.
Your
Publicité
