AL-KO solo FMD 90.6 Mode D'emploi page 31

8. Slowly pull the mower towards you as far as possible.
9. Only now tilt the mower upward (inclination approx. 80°) and hold it.
10. Insert the second pin into the bore so that the mower is kept at the top.
Important! The bolted connection has to bear in the angle as shown on the right picture.
11. You may now let go the mower.
Note!
Please observe that there is sufficient distance to the floor when tilting the mower. (Damage to paint coat)
Translation of the original operating instructions
EN
- 10 -