Publicité
Les langues disponibles
Les langues disponibles
2.
Tilt mower downward
For tilting the mower downward, please follow the procedure below:
1. Hold the mower at the rod and remove the second pin from the bore (picture in 3.5 Functions, no. 1.12).
2. You may now tilt the mower downward and push it back towards the carrier.
3. Slightly lift the mower so that you may release it from the securing hook. Subsequently lower the mower completely (picture in 3.5
Functions, no. 1.6).
4. The V-belt may now be placed on the V-belt disk again. For this purpose, turn the disk so that the V-belt adapts itself on the disk.
5. Use the splint to fix the tow pins on the mower bore again. For the exact position, see picture in 1.2 (item 3.5 Functions).
3.
Dismantle blade for sharpening or replacement
4.
Set mowing height
The mowing height should always be adapted to the current lawn length.
• If a lawn is mown regularly, the height may be set to level 2-3.
• In case of an extended mowing break (holidays), the lawn should be mown in several steps, beginning with level 4.
An insufficient mowing height will result in damage to the lawn and an insufficient mulching of the lawn.
Translation of the original operating instructions
In order to dismantle the blade, the bolt
has to be loosened and the two washers
have to be removed (see picture).
For remounting the blade, the washers
have to be placed in the correct sequence
and fixed with the bolt.
Important! The blades have to be
arranged as shown in the picture. Do not
forget the mounting parts!
EN
- 11 -
Publicité
