Publicité
Les langues disponibles
Les langues disponibles
3.4
Operating elements
1.
Lever for V-belt tensioning
2.
Adjustment lever for setting the mowing height
3.
Adjustment rod for inclination setting
A 1
A 2
A 3
A 4
Translation of the original operating instructions
Push lever slightly to the outside and let it engage at the requested
mowing height.
1 = 30 mm
2 = 45 mm
3 = 50 mm
4 = 65 mm
For optimum mulching, the mower should be inclined forward
A1: For setting, loosen the adjustment rod bolt on one side.
A2: Release the catch spring from the adjustment rod and pull it slightly
upward.
A3: Remove the catch spring from its fixture.
A4: Subsequently turn the adjustment rod until the mower inclines
forward. At the back, the mower should be 2-10 mm higher than at
the front. Subsequently tighten the bolt again.
A1: Now get the adjustment rod engaged in the catch spring again.
The V-belt may be removed from the V-
belt disk by using the lever. Always secure
the lever by a pin inserted in the bore
holes.
Note!
The pin is included in the supply. (Please
also refer to 3.5.1)
EN
- 7 -
Publicité
