AL-KO solo FMD 90.6 Mode D'emploi page 35

7 Troubleshooting
7.1 Safety
Procedure for failures and accidents
1 Initiate emergency stop (leave working position).
2 Stop the carrier.
3 Determine the failure cause.
4 Remedy failure or contact authorized dealer.
7.3 First action for troubleshooting
Failure / Error message
Irregular mowing result
V-belt slips
Mower vibrates
8 Technical data
Machine data
Length, cm
Width, cm
Height, cm
Weight, kg
Working ground
Application area
Cutting width, cm
Cutting height, cm
Cutting height adjustment
Number of blades
Type of mower
Connections / interfaces
Technical modifications reserved!
Translation of the original operating instructions
Remedy
- Blades are blunt
- Mower inclination is inappropriate (see 3.4.3)
- Grass accumulation in mower
- Excessively high speed at insufficient motor rpm.
- Different pressure levels in wheels
- Retension spring at lever for V-belt tension.
- V-belt is not flush in V-belt disks
- Tighten blade bolts
- Blades are imbalanced → replace them by new, original
blades.
FMD 90.6
965
780
430
32
Green areas, lawn
Normal use in facilities and landscaping maintenance
90
from 30mm to 65mm
4 x
2
Mulching / rear discharge
Receiver for mounting on carrier
7.2 Service address
Please contact your sales consultant in case of failures,
problems or otherwise. Please always indicate the solo by
AL-KO product serial no. in inquiries. (Please refer to
nameplate on the solo by AL-KO product or on the Operation
Manual cover).
.
EN
Notes
- 14 -