AL-KO solo FMD 90.6 Mode D'emploi page 38

A2: Mount mower on FC 13-90.6 HD 2WD / 4WD carrier
Step 1
Place the mower in front of the
carrier.
Step 2
Pull the lever for tensioning the
V-belt and fix it with a pin (see
3.4.1).
Step 3
Lift the mower at the back and
place the guide rail on the
receiver bar.
Step 4
Position both sides of the guide
rail and the guide rod as shown
in the picture.
Step 5
Now entirely push the mower
on the receiver bar.
The guide rail nib must be
engaged in the receiver bar
slot, the guide rail must be
placed in the fixture.
Step 6
Place one washer on the bolts
and push the latter through the
bore (PICTURE) on both sides of
the guide rail.
Place another washer at the
other end and fix it with the
hex-nut with some backlash.
Translation of the original operating instructions
EN
1 Receiver bar
2 Guide rail
The following parts
are fixed on the
mower:
2 x bolts
4 x washers
2 x hex-nut
- 17 -