Becker Centronic VarioControl VC210S Notice De Montage Et D'utilisation page 36

Program the master transmitter for the heating element
Press the "Heating element" programming button on the radio receiver for
3 seconds.
► The radio receiver remains in programming mode for 3 minutes.
Now press the programming button of the transmitter for 3 seconds whilst in
programming mode.
► The receiver confirms.
Programming is now complete.
Programming additional transmitters
In addition to the master transmitter, up to 15 further trans-
mitters can be programmed in the radio receiver for both the
lighting system and the heating element.
Press the programmed master transmitter's programming button for 3
seconds.
▻ The receiver confirms.
Now press the programming button of a new transmitter which has not yet
been programmed in the radio receiver for 3 seconds. Doing so activates the
programming mode of the radio receiver for a new transmitter for 3 minutes.
▻ The receiver confirms.
Now re-press the programming button of the new transmitter you wish to pro-
gram for 3 seconds.
▻ The receiver confirms.
► The new transmitter has now been programmed.
36 - en