Publicité
Les langues disponibles
Les langues disponibles
2
Allows the regulation of the arc voltage.
Allows regulation of the arc length during welding.
Manual MIG/MAG
High voltage = long arc
Low voltage = short arc
Minimum 5V, Maximum 55.5V
Synergic MIG/MAG
Minimum -5.0, Maximum +5.0, Default syn
"Consult the instruction manual".
4.5 RC 200 remote control
The RC 200 is a remote control unit designed to manage the
display and the adjustment of all available parameters of the
power source to which it is connected.
"Consult the instruction manual".
4.6 MIG/MAG series torches
1
Torch button
"Consult the instruction manual".
4.7 U/D MIG/MAG series torches
The U/D series torches are digital MIG/MAG torches allowing
the main welding parameters to be controlled:
- welding current
- program recall
(Consult the "Set up" section).
"Consult the instruction manual".
42
4.8 Push-Pull series torches
1
Torch button
"Consult the instruction manual".
4.9 RC kit (WF...Exclusive, RapiDeep Exclusive,
RapiDeep Steel) (73.11.015)
"Consult the "Installation kit/accessories" section".
4.10 Push-Pull kit (73.11.012 WF...Exclusive,
RapiDeep Exclusive, RapiDeep Steel) (73.11.013
WF...Classic, Smart)
"Consult the "Installation kit/accessories" section".
4.11 Feed unit wheels - upgrade kit (73.10.065)
"Consult the "Installation kit/accessories" section".
4.12 Feed unit wheels - upgrade kit (73.10.066)
"Consult the "Installation kit/accessories" section".
4.13 Wire feeder holder kit (73.10.067)
"Consult the "Installation kit/accessories" section".
5 MAINTENANCE
Routine maintenance must be carried out on the
system according to the manufacturer's instruc-
tions.
Any maintenance operation must be performed by qualified
personnel only.
When the equipment is working, all the access and operating
doors and covers must be closed and locked.
Unauthorized changes to the system are strictly forbidden.
Prevent conductive dust from accumulating near the louvers
and over them.
Disconnect the power supply before every opera-
tion!
Carry out the following periodic checks on the
power source:
- Clean the power source inside by means of low-
pressure compressed air and soft bristle brushes.
- Check the electric connections and all the con-
nection cables.
Publicité
