Selco WF 430 ArcDrive Classic Manuel D'instructions page 32

2.1 Lifting, transport & unloading
- The equipment is provided with a handle for hand transportation.
- Use a fork lift truck paying attention during operations in
order to prevent the generator from tipping over.
Do not underestimate the weight of the equip-
ment: see technical specifications.
Do not move or position the suspended load
above persons or things.
Do not drop or apply undue pressure on the
equipment.
2.2 Positioning of the equipment
Keep to the following rules:
- Provide easy access to the equipment controls and connec-
tions.
- Do not position the equipment in very small spaces.
- Do not place the equipment on surfaces with inclination
exceeding 10° from to the horizontal plane.
- Position the equipment in a dry, clean and suitably ventilated
place.
- Protect the equipment against pouring rain and sun.
2.3 Connection
The SELCO mobile units are powered exclusively at low voltage
32
2.4 Installation
Connection for MMA welding (WF 430 ArcDrive Exclusive,
RadiDeep Exclusive, RapiDeep Steel)
The connection shown in the figure produces
reverse polarity welding. To obtain straight polar-
ity welding, reserve the connection.
- Connect (1) the earth clamp to the negative socket (-) (2) of
the power source.
- Connect (3) the electrode holder to thpositive socket (+) (4)
of the power source (WF 430 ArcDrive Exclusive, RapiDeep
Exclusive, RadiDeep Steel).
Connection for MIG/MAG welding
- Disconnect the power supply from the power source.
- Connect the power cable to the appropriate outlet (1).
Insert the plug and turn clockwise until all parts are secured.
- Connect the signal cable to the appropriate connector (2).
Insert the connector and screw the ring nut clockwise until all
parts are secured.
- Connect the gas hose to the pressure reducing valve of the
cylinder or to the gas supply connection (3).
- Connect the water pipe (blue colored
quick connector of the cooling unit.
- Connect the water pipe (red colored
connector of the cooling unit.
) to the outlet
) to the inlet quick