Publicité
Les langues disponibles
Les langues disponibles
5.3
SETTING THE TIMED
STEAM FUNCTION
(Version with timed
steam nozzle without
temperature probe)
• Follow the standard procedure to enter the pro-
gramming function;
• Place the steam nozzle inside the liquid to be
heated;
• Press the steam select key
• The nozzle will begin to dispense steam;
• Press the steam key
ficient amount of steam has been dispensed.
The machine will store this dispensing time to
memory;
• Press the continuous key
gramming function or to go on to program other
selection keys.
5.4
SETTING THE
AUTOSTEAM FUNCTION
(Version with Autosteam)
• Follow the standard procedure to enter the pro-
gramming function;
• Place the steam nozzle complete with tempera-
ture probe inside the liquid to be heated;
• Press the steam select key
• The nozzle will begin to dispense steam;
• Press the steam key
uid has reached the required temperature. The
machine will store this temperature setting to
memory;
• Press the continuous key
gramming function or to go on to program other
selection keys.
5.5
PROGRAMMING HOT
WATER
• Use the relevant procedure to enter the program-
ming function;
• Press the hot water selection key
• Hot water delivery will begin;
• Decide the required amount of hot water and
then press the key
• Press the continued key
ming function or to continue programming other
selection keys.
40
;
again when a suf-
to quit the pro-
;
again when the liq-
to quit the pro-
;
again;
to exit the program-
5.6
PROGRAMMING
STANDARD DOSES
• It is possible to enter pre-set values for the 4
group doses and water (steam).
To do this, it is necessary to press the key
and hold it down for at least 10 seconds until the
flashing keys switch off.
The doses are:
1CN
2CN
40 cc
60 cc
WATER
STEAM
9 sec.
0 sec.
NOTE:
A time setting of 0 seconds for steam and
water means this function will work continually.
5.7
COPYING DOSE
SETTINGS
It is possible to copy the doses stored to memory for
group 1 to the doses for group 2.
This operation is performed by pressing the continu-
ous key
for group 2 and holding it down for at
least 10 seconds until the flashing keys switch off.
5.8
PROGRAMMING
OPERATING
PARAMETERS
The adjustments listed here below must ONLY
be performed by a Specialist Technical Engineer.
If you hold down the
after first entering the programming mode for the
first group, this will access the machine parameters
setting mode; this is signalled by the continuous key
or the second group, which will switch on
1. Enabling the pump if the level is enabled.
2. Enabling the software block to enter the dose
programming function.
3. Adjusting keypad brightness.
4. Enabling the hot water pump (on machines
EN
1CL
2CL
50 cc
85 cc
STEAM TEMP.
50°C
CAUTION
key of the second group,
Publicité
