Anselmo Cola TOPFIRE 70 SLIM Manuel D'installation, D'utilisation Et D'entretien page 49

4.2.4 Additional remote control functions
The display on the remote control shows all the information on insert operation.
The basic functions are:
STATUS
OFF
START
PELLET LOADING
AWAITING FLAME
FLAME PRESENT
WORK
MODULATE– MODULATE F
BRAZIER CLEANING
FINAL CLEANING
STANDBY
AWAITING COOL-
The remote control has a keylock function. This is available only if enabled by the specialized technician during the
first installation.
From the main menu, press buttons P7
and P3 in rapid succession, to activate
or deactivate the keylock function.
The two messages shown opposite
appear on the display.
Press button P7 to access the list of submenus. They allow the electronic controller settings to be changed. The
various submenus can be scrolled by pressing buttons P1 and P2, and can be accessed by pressing button P7 and
exited by pressing P3.
MENU 02 – Set clock
Before operating the insert, the current time and date must be set in order to have a reference for possible chrono
programming.
The electronic control has a 3-volt lithium battery model CR2032 that gives the internal clock an operation
autonomy; battery replacement is necessary if the clock does not keep the time with the insert not powered, or a
series of zeros appears at restart: call an authorized service center.
To set the clock, access the menu by pressing P7 and set the day with buttons P1 and P2. Press P7 again to set
the hours, minutes, day, month and year.
MENU 03 – Set chrono
Allows all time programming functions to be enabled/disabled. To enable the chrono, access the first submenu
ENABLE CHRONO and set it to ON with buttons P1 or P2. The manual commands from the emergency panel or
remote control have priority over programming.
The insert is equipped with three different types of programming: daily, weekly and weekend.
Chrono enabling is signaled by the LEDs shown in the picture below. Daily, weekly and weekend programming is
active only if the general chrono is enabled.
Enable chrono
Insert off
The initial ignition start phase is in progress
Pellet loading in progress during the ignition phase
This is the phase prior to the flame appearing.
The flame has appeared and the insert is in the heating phase
Normal work phase
Power reduced because temp. reached or high fume temp.
Automatic cleaning at regular intervals
Final insert cleaning, before shutdown
Insert off for temperature reached and awaiting request
The insert cannot be relit because awaiting cooling
49
DESCRIPTION
Enable weekend programming
Enable weekly programming
Enable daily programming
TOPFIRE 70 SLIM