Publicité
Les langues disponibles
Les langues disponibles
Installation and Operating Instructions
m
DANGER
NOTE
NOTE
NOTE
Central ventilation units AIR1 XVP
After selecting manual operation mode, the ventilation unit will run with the adjusted setpoints for the respective stage.
m
Danger to life due to electric shock!
An electric shock can result in death or serious injury�
The unit is still live after selecting "Off" via the controller. The unit switches to standby mode.
Constant pressure ventilation mode: Only one ventilation stage is available in this mode. If a ventilation stage is manu-
ally selected, the ventilation unit will always run with the set pressure setpoint.
Controller AIR1-BE TOUCH 2: The ventilation switches back to timer mode after the set "Back to timer" time has
expired. The same applies for the manual selection of "Off".
If continuous manual operation is set, the adjustable "Back to timer" time must be set to zero.
f continuous manual operation is set, the adjustable "Back to timer" time must be set to zero.
4�1�2 Timer
In order to activate the "Timer" function, the timer mode must be set as operating mode. The unit will only run once the
timer intervals have been set. If multiple time intervals are active at the same time, the function with the highest priority
will be activated. If no intervals have been set, the unit will not run.
The manual operation and switch contacts block the timer function.
a� Time/Date
In order to set the time and date, you must first log on as User or Admin. Press the
Press the
button again to enter the "Time/Date" menu. Press the
menu and confirm by pressing the
Temperature
Fan control
→ Timer
Access rights
→ Time/Date
Timer Normal
Timer Reduced
Timer Boost
Time: XX:XX
Date: XXXX-XX-XX
Day: XXXXX
b� Daily/weekly programme
The timer mode has an adjustable weekly programme with two operating intervals for each ventilation stage on each
day of the week.
Special feature Controller AIR1-BE TOUCH 2: Four operating intervals for each ventilation stage on each day of the
week.
The following ventilation stages/functions are available:
• Timer Reduced
• Timer Normal
• Timer Boost
• Timer VOD (accessories required, sensor-controlled operation)
• Timer Recirculation (accessories required)
If no ventilation stages/functions are selected, the unit will not run (standby).
Set weekly programme:
• Log on as User or Admin
• Call up the timer settings menu
• Call up the selected timer
• Set timer for all days
→ Time/Date
Timer Normal
Timer Reduced
Timer Boost
→ Timer VOD
Timer Recirculation air
Holiday
Overrun
button.
OK
OK
OK
OK
43
button to select the time settings.
button to set the time and date in the "Time/Date"
OK
OK
EN
Publicité
