Publicité
Les langues disponibles
Les langues disponibles
Searching for a service by name (Quick-
BrowZer™)
You can display a list of services for easy searching.
1
During DAB reception, press
The unit enters Quick-BrowZer mode, and the
list of services appears.
2
Rotate the control dial to select the
desired service, then press it.
Reception starts.
To exit the Quick-BrowZer mode
Press
(browse).
Setting DAB announcements
Specific types of DAB announcements that you set
can interrupt the currently selected source.
1
During DAB reception, press MENU,
rotate the control dial to select
[GENERAL], then press it.
2
Rotate the control dial to select
[ANNOUNCE], then press it.
3
Rotate the control dial to select the
desired type of announcement, then
press it.
4
Rotate the control dial to select [ON] or
[OFF], then press it.
Notes
The DAB announcement feature is available when
turned to other than the MW/LW bands.
During a DAB announcement, the volume is adjusted
to the level set for TA in RDS (page 11).
Type of announcement
ALARM (Alarm), TRAFFIC (Road Traffic Flash),
TRAVEL (Transport Flash), WARNING (Warning/
Service), NEWS (News Flash), WEATHER (Area
Weather Flash), EVENT (Event Announcement),
SPECIAL (Special Event), RAD_INFO (Program
Information), SPORTS (Sport Report), FINANCE
(Financial Report)
To listen to the same program even during
weak reception
Set [FM LINK] to [ON] (page 17).
[FM-LINK] lights up when the corresponding FM
program is being received.
10
GB
Updating the service list automatically
(Auto scan)
1
Press MODE to select [DAB1], [DAB2] or
[DAB3].
(browse).
2
Press MENU, rotate the control dial to
select [GENERAL], then press it.
3
Rotate the control dial to select
[AUTOSCAN], then press it.
The unit updates the list of services in Quick-
BrowZer mode.
Using FM/MW/LW
Storing automatically (BTM)
1
Press MODE to change the band (FM1,
FM2, MW or LW).
2
Press MENU, rotate the control dial to
select [GENERAL], then press it.
3
Rotate the control dial to select [BTM],
then press it.
The unit stores stations in order of frequency on
the number buttons.
Tuning
1
Press MODE to change the band (FM1,
FM2, MW or LW).
2
Perform tuning.
To tune manually
Press and hold SEEK +/– to locate the
approximate frequency, then press SEEK +/–
repeatedly to fine adjust to the desired
frequency.
To tune automatically
Press SEEK +/–.
Scanning stops when the unit receives a station.
Repeat this procedure until the desired station
is received.
Storing manually
1
While receiving the station that you want
to store, press and hold a number button
(1 to 6) until [MEM] appears.
Publicité
