Publicité
Les langues disponibles
Les langues disponibles
Passenger seat lock and helmet holder
Opening (fig. 28)
Insert the key into the seat lock (1) and turn it clockwise
until the seat hook disengages with an audible click.
Lift the rear of the seat and slide it backwards off the
front mountings.
E
Closing
Fit the seat over the tank mountings and pull it backwards
until it engages.
Press down on the rear of the seat until you hear the lock
engage with an audible click.
Make sure the seat is fully engaged by gently pulling it
upwards.
The hook for the helmet holder cable is located under
the passenger seat. Pass the cable (A) through the
helmet and fit the ends of the cable into the hook.
Leave the helmet hanging on the left side (fig. 29) and
refit the seat to secure it.
Warning
This device protects the helmet against theft when the
motorcycle is parked. Do not leave the helmet attached in
this way when riding the motorcycle as it can interfere with
riding and cause loss of control of the motorcycle.
Hang the helmet cable from the left side of the motorcycle.
In any other position the cable will interfere with the seat
closure.
36
OPEN
1
fig. 28
fig. 29
Publicité
