Publicité
Les langues disponibles
Les langues disponibles
Procedure to disable immobilizer engine
block through throttle twistgrip
1) Turn the ignition key to ON and fully open the throttle.
Keep it open.
The EOBD warning light (3, fig. 6) turns off after
8 seconds.
2) Release the throttle as soon as the EOBD warning
E
light turns off.
3) The EOBD warning light will flash. Now enter the
electronic release code shown on the CODE CARD
given to the customer at the time of consignment of
the motorcycle by the dealer.
4) Count a number of flashes of the EOBD light
equivalent to the first number of the secret code.
Open full throttle and keep the position for 2 seconds,
then release. In this way the input of one figure is
acknowledged, the EOBD warning light comes on
and stays on for 4 seconds. Repeat the operation
until you have entered the final digit.
If you fail to perform any operation with the throttle
the EOBD light will flash 20 times and then illuminate
steadily to inform you that the procedure must be
repeated from step 1.
24
5) When you release the throttle grip, if the code has been
entered correctly the following two cases may occur:
A) the EOBD light starts flashing to indicate that engine
is enabled. The light switches off after 4 seconds, or if
engine speed exceeds the threshold value of 1000 rpm.
B) the IMMO warning light (3, fig. 5) flashes until
engine speed rises above 1000 rpm, or until the
engine is re-started.
6) Should the code NOT be entered correctly both the
EOBD and IMMO lights stay on and it is possible to
repeat the procedure starting again from point 2 for
as many times as necessary.
Notes
If you release the twistgrip too soon, the warning
light comes on again. Return the ignition key to OFF and
repeat the procedure from step 1.
Publicité
