SDMO RL6-1b Manuel D'utilisation Et D'entretien page 61

Unlock the side slides by pulling the lock (fig 5.2 – no. 1).
Manually remove the side slides (fig 5.2 – no. 2). and check that the locks engage correctly in the relevant locking holes.
Unlock the stabilisers (side and rear) by pulling the pin out its hole and position them so that they can be lowered (pin in the hole
provided). Lower the stabilisers (fig 5.2 – no. 3). by turning the handles (figures 5.2 and 5.3).
All the stabilisers must be correctly deployed before the column is raised.
Prior to first using the lighting column, it is recommended that you familiarise yourself with the operation of all
the installation's controls.
Important
Figure 5.2 – Removing the stabilisers
Side stabiliser
Figure 5.3 – Close-up view of a crank handle
59/372
Rear stabiliser