Migatronic SIGMA SELECT 300 S Guide De L'utilisateur page 16

Connection and start-up
Assembly of parts in wire feed unit
Wire inching forward/backward
When idling, wire inching can be activated by pressing one of
the keys or activated at the robot interface, if the MWF30 unit
is used in a robot setup.
Wire inching
Wire inching MWF 30
0.5-30 m/min
Wire inching Graphical
07:07
Wire feeder
Program
Process setup
Wire feeder
Machine setup
x4
Software update
• Insert the SD-card
• Turn on the machine
• Wait until the unit indicates
that the update is complete
• Turn off the machine and
remove the SD card
0.5-30 m/min
• The machine is now ready
for use
New software will be loaded into
power source and all connected
units.
The software can be
downloaded from
http://migatronic.com
card. The file system of the
SD card must be formatted to
FAT32.
IMPORTANT:
Save the software in the //MIGA_SW/SIGMA/ file structure.
Licence SW
0.5-30 m/min
If you purchase additional licences for programs or special
funtions, load the MigaLic.dat files like the software packages.
Note! Create a backup of the files.
The MigaLic.txt file contains information about licence number
and licences saved on SD card.
16
The pressure of the thumbscrew
is adjusted to allow the wire feed
roll just to slide on the wire when
this is stopped at the contact tip
to an SD