Migatronic SIGMA SELECT 300 S Guide De L'utilisateur page 22

Technical data 2
WIRE FEED UNIT MWF
Wire feed speed, m/min
Torch connection
Wire-reel diameter, mm
Wire spool, kg
Duty cycle 100 % 40°C, A
Duty cycle 60% 40°C, A
Duty cycle max. 40°C, A/%
3) Protection class
Wire diameter, mm
Gas pressure, MPa (bar)
Dimensions (HxWxL), mm
Weight, kg
Standards
COOLING UNIT MCU 1300
Cooling efficiency (1 l/min), W
Cooling efficiency (1.5 l/min), W
Tank capacity, liter
Flow, bar - °C - l/min
Pressure max., bar
Standards
Dimension s (HxWxL), mm
Weight
EC DECLARATION OF CONFORMITY
MIGATRONIC A/S
Aggersundvej 33
9690 Fjerritslev
Denmark
hereby declare that our machine as stated below
Type: SIGMA SELECT
conforms to directives: 2014/35/EU
2014/30/EU
2011/65/EU
European standards: EN IEC60974-1:2018/A1:2019
EN IEC60974-2:2019
EN IEC60974-5:2019
EN IEC60974-10:2014/A1:2015
Regulation: 2019/1784/EU
Issued in Fjerritslev 10.02.2021
Kristian M. Madsen
CEO
1) This equipment complies with EN / IEC61000-3-12:2014 (/ 2011) provided that the short-circuit power Ssc of the grid at the interface point is greater than or equal to the stated
data in the abovementioned table. It is the responsibility of the installer or user of the equipment to ensure, by consultation with the distribution network operator if necessary, that
the equipment is connected only to a supply with a short-circuit power Ssc greater than or equal to the stated data in the abovementioned table.
2) S This machine meets the demand made for machines which are to operate in areas with increased hazard of electric chocks.
3) The machine is designed for indoor and outdoor use according to protection class IP23 / IP23S.
IP23S: The machine may be stored but is not intended to be used outside during precipitation unless sheltered
0.5-30.0
EURO
300
5-18
430
500
550/50
IP23
0.6-1.6
0.6 (6.0)
MWF 30 MWF 32 MWF 33
413x310x750 457x260x672.5 457x260x672.5
11.6 14.0 14.0
IEC60974-5, IEC60974-10 CL. A
1300
1600
5
3.0-60-1.5
5
IEC60974-2. IEC60974-10 CL.A
207x260x680
20
22