FITTING TYRES ON WHEELS WITH
SPLIT RING
After lubricating the surface of the rim and
the tyre beads with the special grease, fit the
tyre complete with inner tube and flaps onto
the wheel. Place the tyre on the table, place
the rim coaxial with the tyre, move the jaw
forward so that the tyre is inserted onto the
rim, and fit the inner tube valve in its seat.
Press the second bead with the disk until the
seats of the elastic rings on the rim are free,
then fit the locking rings (Fig. 26).
Care must be taken to place the disk in front of
the locking ring during inflation (Fig. 27).
46
25
FIRE-FIGHTING EQUIPMENT
The machine consists of a variety of very dif-
ferent parts, so the measures to be taken in
case of fire must also be different.
When choosing the most suitable extinguisher,
follow the table below:
trical
ment
Water
Foam
Powder
CO2
The information provided in this table is of
a general nature and is intended to provide
users with general guidance. Ask suppliers
about the possible uses of each type of
extinguisher.
MAINTENANCE (FOR
REPAIR ENGINEERS ONLY)
26
a)After the first few working hours, check and
tighten unions, bolts and nuts (if necessary)
Dry
Inflammable
materials
liquids
Yes
No
Yes
Yes
Yes
Yes
Yes
Yes
CAUTION
EXTRAORDINARY
- E
- Operator's manual
nglIsh
27
Elec-
equip-
No
No
Yes
Yes