Mondolfo Ferro TB 126 S Manuel D'utilisation page 43

wheel, moving the turntable in the opposite
direction to the previous operation (Fig. 13).
- E - Operator's manual
nglIsh
11
12
Continue the bead breaking operation, moving
the disk around the edge of the rim, until the
tyre has been completely removed (Fig. 14).
To fit the tyre, fix the clamp on the edge of the
rim in the high position, place the two beads on
it and operate the disk against the tyre (after
lubricating the beads and the edge of the rim)
(Fig. 15-16).
To remove the first edge of the tyre with the tool,
move it forward, inserting it between the bead
and the rim so that it takes hold of the bead and
stretches it, then place the lever under the tool
(7 Fig. 1), bring the bead outside the edge of
the rim and use the control (3 Fig. 4) to rotate
the turntable anti-clockwise (Fig. 17-18).
13
14
43