BIOTRONIK Reocor S Manuel Technique page 14

11
Designation
1 Patient connection
INDIFF.+; DIFF.-
2 Battery compartment
3 Low battery LED
4 LED Pace
5 LED Sense
6 Ampl. control dial
7 Sens. control dial
8 Start burst
9 Velcro harness
10 Burst rate control dial
11 Select burst
12 Rate control dial
13 Mode dial
Table 1: Description of elements in Figure 1
Figure 2: Correct positioning of the protective cover
Function
For cables with 2-mm plug or for Redel adapters
(red = plus; blue = minus)
For 9-V block battery
Provides a warning when the battery voltage is too low
Yellow display for stimulated event
Green display for sensed event
Setting the pulse amplitude
Setting the sensitivity
Starting the burst function
Secures Reocor S to patient, bed or infusion stand
Setting the burst rate
Selection of the burst function
Setting the pacing rate
Selection of the pacing mode and off switch
Bold labels of the operating devices indicate safe values for
the intended use of the device.
Protective Cover
The protective cover is locked when the cover has been
pushed to the stop, passing two snap-in points and when the
lever is resting on the rail (see Figure 2).
Correct: False: