SCHUBERTH C3 PRO Mode D'emploi page 45

Warning:
EN
Never use the helmet with the lining removed!
If the lining is not installed before use, the helmet may not fit properly
and could come off in an accident, resulting in severe head injury
or death. Excessive heat (e.g. exhaust heat) can cause damage
tographics, the inner shell of the helmet and the interior lining!
Warning:
Never modify your helmet!
It is very dangerous to drill holes or to cut the shell and/or the shock
absorbing liner. Modification can seriously weaken the helmet. Modifying
the retention system weakens it, increasing the likelihood of snapping
during impact. Removing parts such as the mouth guard or rubber face
molding can expose edges that may injure you in an accident. Always
use approved SCHUBERTH parts when replacing shields, screws, or
any other parts. A weakened helmet will not provide head protection.
Warning:
Do not repaint the helmet!
Repainting of your helmet is not recommended. Certain types of paint
and thinner can damage the helmet and reduce its ability to provide
head protection in an accident.
Warning:
Avoid direct contact with aggressive substances!
The direct effect of motor fuels, thinners or solvents can destroy the
structure of the inner and outer shell. Make sure the helmet does not
come into contact with such substances, even for cleaning purposes!
Warning:
Clean your helmet carefully!
Caution:
Do not carry the helmet on the motorcycle's helmet storage lock while
riding in order to avoid exhaust pipe burns, tire abrasion, and strap
damage to the helmet.
Caution:
Keep the helmet outside the reach of pets to avoid the helmet being
damaged by chewing, scratching or other mistreatment.
45