SCHUBERTH C3 PRO Mode D'emploi page 19

OPENING AND CLOSING
To close the chinstrap fastener, slide the ratchet tongue step by step into
the locking buckle. If you find that the chinstrap fits too loosely around your
chin, slide the ratchet tongue one step further into the locking buckle.
When adjusting the chinstrap, make sure that it rests firmly but not
uncomfortably around your chin. To open the chinstrap, pull the red ribbon
on the ratchet fastener upwards to release the locking buckle. Then pull the
ratchet tongue out of the locking buckle.
Warning:
Never ride without making sure that the chinstrap is correctly
fastened and adjusted and properly positioned under the chin. If the
chinstrap is not correctly adjusted or fastened, the helmet could be
displaced in the event of an accident.
Warning:
Do not twist the strap! The indented part of the tongue must be
facing the inside of the helmet!
Warning:
Closing the comfort pad of the chinstrap alone will not provide
adequate protection. The chinstrap must always be fully fastened,
using the adjustable chin strap.
Warning:
Never open the chinstrap while riding.
Warning:
Pull the red strap only to remove your helmet! Never pull the red strap
while riding!
EN
19