SCHUBERTH C3 PRO Mode D'emploi page 46

G. FOR YOUR SAFETY
2. SAFETY ADVICE – FACE SHIELD / SUN VISOR
Warning:
Keep your helmet (face shield and sun visor) in good condition!
If your face shield or sun visor become too scratched or uncleanable,
replace it with a new one. Impaired visibility causes accidents. Clean
your face shield and sun visor only with mild soap diluted in tap water.
Rinse well with clean tap water, and dry with a soft cloth. Never use
benzene, gasoline, glass cleaner or any other solvents. Do not attach
stickers or adhesive tape to the face shields and sun visor, as this will
weaken the hard coating, damaging them. Do not drive with a dim or
blurred shield. Impaired vision can cause an accident resulting in serious
personal injury or death.
Warning:
Remove protective film before using the helmet!
The protective film fastened to the face shield to protect it from
scratches in transit must be removed before use.
Warning:
Keep the helmet away from aggressive substances.
Motor fuel and solvent vapor can cause the face shield and sun visor to
crack. Keep the face shield and sun visor away from such vapors and do
not allow kinds of substances to come into direct contact with the face
shield or sun visor! For thatreason, never place the helmet on the tank
of your motorcycle.
Warning:
Don't ride when visibility is poor!
Make sure the face shield and sun visor are always in perfect condition.
If for any reason, the visibility is poor, don`t ride.
Warning:
Don't ride with a fogged up face shield.
Never try to manually clean a fogged up face shield while riding, this
could cause an accident resulting in serious personal injury or death.
In light stages of misting you may either open the chin ventilation or
the face shield to the town position. If the fogging is not immediately
reduced stop your ride.
46