Measurement Results - VISIOMED Bewell Connect MyECG Mode D'emploi

a relaxed position for full duration of the measurement.
3. Ensure the electrodes are in direct contact with your skin (fingers) as shown with your left
and right index fingers on the top electrodes, and your left and right thumbs on the side
electrodes.
4. Press the start button to begin a measurement.
5. The device will display a 6 second countdown, and then it will start the recording.
6. During the 30 seconds recording, a heart will flash on the screen and a chime will sound
for each detected heart beat. A flashing clock icon indicates time remaining in the record-
ing. The screen will display a HR waveform if the device is unlocked (refer to "Enable Heart
Rhythm Display" below).
7. Remain still, and do not flex or move your fingers or arms until the 30 seconds recording is
complete. If the device senses poor contact or the measurement is interrupted by a hand
adjustment, you will need to repeat the recording.
2.7.2. HEART RATE MEASUREMENT : CHEST MEASUREMENT
See B 2 page 3
Chest measurement for men
If a hand measurement is not ideal, use the device to take a chest measurement. Hold the
device with your right hand and place the other electrode against the left side of your chest
on bare skin about 5 cm (2 in) below the left nipple.
Chest measurement for women
Position the device at the lower end of the breastbone and move horizontally to the mid-
dle of the left part of the chest. If necessary, lift the breast and place the left end electrode
under the left breast.
2.7.3. HEART RATE MEASUREMENT : CABLE MEASUREMENT
See B 3 page 3
WARNING: DO NOT USE WITH A CARDIAC PACEMAKER OR DEFIBRILLATOR.
Connect with fingers
1. Connect the ECG cable with the device.
2. Press the power button to turn on the device.
3. Sit in a comfortable position, your back straight and keep your fingers and arms in
a relaxed position for full duration of the measurement.
31 BewellConnect - BW-HR1 - User Manual - 042016
4. With the clip clamp your fingers, as shown in the following picture. Make sure
the electrodes are in direct contact with right fingers.
- Red electrode on one of the right hand fingers.
- Yellow electrode on one of the left hand fingers.
- Green electrode on another left finger. We recommend index finger, middle finger or ring
finger.
Stick on the chest
Make sure that you are relaxed and that your chest is free of tension. Press the chest elec-
trodes close against your bare chest. Do not place the electrodes on clothing as this will
result in an inaccurate measurement.
- Red electrode : put it under the clavicle, next to the right shoulder.
- Yellow electrode : put it under the clavicle, next to the left shoulder.
- Green electrode : put it at the left of the underbelly.
2.8. WRONG OPERATION METHODS
- Connect wrong cable mount.
- Electrodes contact wrong position of the body.
WARNING : Users are strictly prohibited to attach the lead cable electrodes on their body if the
lead cable is not connected with the device. Before measurement, firstly the lead cable should be
connected with the device, secondly the lead cable electrodes should be attached to your body.
After measurement, firstly the lead cable electrodes should be removed from body, secondly the
lead cable should be disconnected with the device.

2.9. MEASUREMENT RESULTS

View the measurement analysis
After the measurement is complete, the device will display the
heart rate, and a finding of "Stable Waveform" or "Unexpected HR".
The measurement is automatically saved in the device's memory.
If you see "Unexpected HR", repeat the preparation and measurement
steps above. If you have followed all measurement instructions in this
guide, and continue to receive "Unexpected HR" messages, consider
consulting a physician. The cause for an Unexpected HR may be a
poor quality recording or the presence of a fast or slow heart rate.
BewellConnect - BW-HR1 - User Manual - 042016 32