Electrolux EOC6631 Notice D'utilisation page 34

34 www.electrolux.com
Problem
The oven does not heat up. The fuse is released.
The lamp does not operate. The lamp is defective.
The core temperature sen-
sor does not operate.
There is water inside the
oven.
The steam cooking does
not work.
The steam cooking does
not work.
It takes more than three mi-
nutes to empty the water
tank or the water leaks from
the steam inlet opening.
It takes too long to cook the
dishes or they cook too
quickly.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "C2".
The display shows "C3".
Possible cause
The plug of the core tem-
perature sensor is not cor-
rectly installed into the
socket.
There is too much water in
the tank.
Lime obstructs the hole.
There is no water in the
tank.
There are lime deposits in
the oven.
The temperature is too low
or too high.
You left the dish in the oven
for too long.
You want to start the Pyrol-
ysis or the Defrost function,
but you did not remove the
core temperature sensor
plug from the socket.
The cleaning function does
not operate. You did not
fully close the door, or the
door lock is defective.
Remedy
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact a
qualified electrician.
Replace the lamp.
Put the plug of the core
temperature sensor as far
as possible into the socket.
Deactivate the oven and
wipe the water with a cloth
or sponge.
Check the steam inlet
opening. Remove the lime.
Fill the water tank.
Clean the water tank. Refer
to "Cleaning the water
tank".
Adjust the temperature if
necessary. Follow the ad-
vice in the user manual.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the cook-
ing process ends.
Remove the core tempera-
ture sensor plug from the
socket.
Fully close the door.