Clock Function; Setting The Minute Minder; Count Up Timer - Electrolux EOC6631 Notice D'utilisation

12 www.electrolux.com

Clock function

Press
switch between the clock
functions.
To confirm the settings of the
clock functions, press
wait 5 seconds for an
automatic confirmation.
6.2 Setting the DURATION or
END
1. Press
display shows
or
2. Press
and press
For Duration
and then the hours, for End
set the hours and then the minutes.
An acoustic signal sounds for 2 minutes
after the time ends.
time setting flash in the display. The oven
stops.
3. Turn the knob for the oven functions
to the off position.
4. Press any button or open the oven
door to stop the acoustic signal.
If you press
the hours for DURATION
the appliance goes to setting of
the END

6.3 Setting the MINUTE MINDER

1. Press
DURATION
END
again and again to
again and again until the
or .
flashes in the display.
or to the set the values
to confirm.
first you set the minutes
or
when you set
function.
.
Application
To set how long the appliance operates. Use only
when an oven function is set.
To set when the appliance must deactivate. Use only
when an oven function is set. You can use Duration
and End at the same time (time delay), if the appliance
is to be activate and deactivate automatically later.
and "00" flash in the display.
2. Press
MINDER.
First you set the seconds, then the
minutes and then the hours.
At first, the time is calculated in
or
minutes and seconds. When the time
you set is longer than 60 minutes, the
symbol
The appliance now calculates the time in
hours and minutes.
3. The MINUTE MINDER starts
automatically after five seconds.
After 90% of the set time, an acoustic
signal sounds.
4. When the set time ends, an acoustic
signal sounds for two minutes.
"00:00" and
Press any button or open the oven
door to stop the acoustic signal.
first you
symbol and

6.4 Count Up Timer

Use the Count Up Timer to monitor how
long the oven operates. It is on
immediately when the oven starts to heat.
To reset the Count Up Timer, press and
hold
,
up again.
or to set the MINUTE
comes on in the display.
flash in the display.
If you set the MINUTE MINDER
when the DURATION or END
function operates, the symbol
comes on in the display.
and . The timer starts to count
The Count Up Timer cannot be
used with the functions:
Duration , End
temperature sensor.
, core