Saf-Fro DIGIWAVE III Instructions D'utilisation Et D'entretien page 35

6.3. EXTERNAL COMMUNICATIONS
Communication with a USB key is possible as soon as a USB key is detected by the power source.
Communication with remote host via Ethernet connection is possible:
 If the power source is equipped with IP address. Menu Configuration > Network > Network configuration
There are two ways to affect IP address to the power source:
- DHCP: automatic recovery of IP address
- Manual: manual entry of the network parameters
 If the remote host is defined into the power source. There are two ways to of remove host:
- Other power source with IP address
- Computer with FTP server on the port 21
External communications distinguish two main functions:

Only exportable data: Traceability / Faults History / Counters

Exportable and importable data:Welding programs / Power source configuration (see below) / Installation Backup /User Synergies
Import/Export of welding programs and power source configuration is available in the menu:
Configuration > Import/Export
This page allows managing the input/output to Ethernet and USB of the following data:
Welding programs
Program lists
MIG 4T Program Lists
Power source configuration
User interface
Installation
User management
Network configuration
Network hosts
Traceability configuration
DIGIWAVE III
1 Pre-gas
2
Slows wire forwarding
3 Softstart
4 Hotstart
5 Welding
6/7/8 Craterfiller
9 Burnback
10 Postgas
All the existing welding programs and lists on the power source
All the parameters stored into the menu Configuration > User interface
All the parameters stored into the menu Configuration > Installation
All the users and the access rights
Network configuration of Configuration > Network > Configuration
Remote hosts of Configuration > Network >Hosts
Traceability configuration of Traceability >Configuration
EN
35