Saf-Fro DIGIWAVE III Instructions D'utilisation Et D'entretien page 21

3. The third step is the saving of the User Synergy. The power source allows the creation of up to 50 User Synergies. Make sure all of the fields
are filled in order to easily find the references and using conditions of the User Synergy created. Press Ok to validate the field or Escape to go
back and modify the former field.
The created User Synergies are accessible in the Synergy bar of the menu MIG. You can export created synergies from the menu User Synergy by
pressing the export button.
From the User Synergy menu, you can suppress created synergies by pressing the button of synergy suppression.
4.2. MIG WELDING CYCLE ADVANCED SETTING
PRESENTATION OF PROGRAMS
The program management is the same for the 3 welding processes MIG, MMA and TIG.
Working programs : MIG, MMA & TIG
By default, the welding tuning pages of the processes MIG, MMA & TIG use the working programs: MIG, MMA & TIG.
This program provides a working base allowing immediate welding once the quick settings are done.
This program cannot be saved and all the modifications done on it will be lost after a restart of the power source. It cannot be part of a programs list nor
exported.
For thorough use, you need to create numbered programs. The DIGIWAVE III can contain up to 100 Programs.
DIGIWAVE III
1
Current program status
2
Program management menu
The new synergic curve (in red) is different from the
former one thanks to the chosen settings.
EN
21