Operating Elements And Connections; Safety Notes - Monacor Security AV-420SET Mode D'emploi

Please unfold page 3. Thus you will always be able
GB
to see the operating elements and connections
described.
1

Operating Elements and Connections

1.1 Camera
1 Key for setting the focus
2 Lens, can be turned with the key (1) for focus setting
3 Camera support
4 Transmitting antenna
5 Low voltage jack for connection of the supplied
charger
6 Charging LED "Charge", lights up when the internal
rechargeable battery is being charged
7 "Power" LED
8 Channel switch and on/off switch
19 Low voltage plug of the 5 V charger
1.2 Receiver
10 Reception antenna
11 Antenna connection (SMA jack)
12 LEDs for indicating the adjusted channel
13 Button SET for channel adjustment
14 POWER switch
15 Connection jack DC12V for the supplied plug-in
power supply unit
8
16 AUDIO output (phono)
17 VIDEO output (phono)
18 Low voltage plug of the 12 V power supply unit
2

Safety Notes

The units (camera, receiver, charger, and plug-in
power supply unit) correspond to all required directives
of the EU and are therefore marked with
WARNING The charger and the plug-in power supply
unit are supplied with hazardous mains
voltage (230 V~). Leave servicing to
skilled personnel only. Inexpert handling
may cause an electric shock hazard.
Please observe the following items in any case:
The camera must not be operated near cardiac
pacemakers (minimum distance 25 cm) and medical
appliances. The electromagnetic radiation may lead
to interference.
The units are suitable for indoor use only. Protect
them against high air humidity, dripping water and
splash water, and extreme temperatures (admissible
ambient temperature range -10 °C to +50 °C).
Even if the camera and the receiver are switched off,
the charger or the plug-in power supply unit connected
to a mains socket has a low power consumption.
Do not set the receiver or the camera into operation,
and immediately disconnect the corresponding
.