Use - Cleanmaxx YF-418-12 Mode D'emploi

EN

Use

NOTE!
■ Never use the device without water to prevent damage to the device!
■ There must be plenty of space around the item of clothing which is to be smoothed.
You may only perform vertical smoothing if the item of clothing is hanging on a hang-
er and cannot come into contact with other garments, objects, people or animals.
■ CAUTION – Danger of scalding! Only use the device once the control lamp has
gone out. Operating temperature has then been reached. If the device is used be-
fore the control lamp has gone out, hot water may escape.
■ Before using the device, read the care instructions for the fabric which is to be
smoothed. Some fabrics, leather and suede as well as fabrics with fl ounces,
sequins and appliqués must not be steamed!
1. Mount the attachment you want (see the "Mounting / Removing Attachments" chapter).
2. Pour water into the water reservoir (5) (see the "Filling the Water Reservoir" chapter).
3. Insert the mains plug into a properly installed plug socket that is easily accessible.
The control lamp (1) lights up and the device starts to heat up. When the control lamp
goes out, the device is ready for use.
If the control lamp lights up during use, the device is reheating. Do not press the
steam release button during the heating process in order not to slow this down
and to prevent a danger of scalding from hot water which may escape. Wait until
the control lamp goes out again.
18
4. Move the device without attachment in strokes over the fab-
ric and press the steam release button (2) at regular intervals
as you do so. However, do not keep the steam release
button held down constantly! It is important for the steam
bottom (8) to touch the fabric so that it is freshened up.
5. Move the brush attachment (6) in strokes over the fabric
and press the steam release button at regular intervals as
you do so. However, do not keep the steam release button
held down constantly! It is important for the brush attach-
ment to touch the fabric so that it is freshened up.
6. Open the clip of the crease attachment (7) by pressing the
lever slightly towards the device. Clamp the fabric of the item
of clothing to be smoothed in the crease attachment and let
go of the lever again. Slowly pull down the item of clothing
and press the steam release button at regular intervals as
you do so. However, do not keep the steam release button
held down constantly!