EMAK CR 450 Manuel D'utilisation Et D'entretien page 37

- A l l a d j u s t m e n t s o r m a i n t e n a n c e
operations not described in this manual
must be carried out by an Authorised
Service Centre, which has the necessary
expertise and equipment to ensure that
the work is done correc tly without
affecting the safety of the machine.
Operations performed in unauthorised
centres or by unqualified persons will void
all forms of warranty and all obligations or
l i a b i l i t i e s o f t h e m a n u f a c t u r e r. I n
par ticular, you should contac t your
Authorised Service Centre immediately if
you encounter malfunctions affecting the
brake, the engagement and stopping of
the brake or the drive engagement in
forward or reverse gear.
- The silencer and other parts of the engine
(e.g. cylinder fins, spark plug) become hot
during operation and remain hot for a
while after the engine is stopped. To
reduce risk of burns do not touch the
silencer and other parts while they are hot.
- Frequently check for the accumulation of
dry grass or similar materials, around the
engine and especially around the exhaust
pipe; carry out periodic cleaning and
remove even the smallest quantities of
such materials.
- Never modify the machine in any way.
- Replace safety devices as soon as they
become damaged or broken.
- Keep all nuts, bolts and screws tightened to
guarantee safe operating conditions.
7.2 Routine Maintenance
The following list is to help you maintain your
machine's safety and performance. It shows the
main maintenance and lubrication operations
and their frequency.
Machine
1. Check and adjustment of the
throttle lever (2)
2. Check and adjustment of the
clutch lever (2)
3. Check and adjustment of
parking brakes (2)
4. Check and adjustment of
crawlers unlock levers (2)
5. Crawlers rollers lubrication
with grease
6. Check transmission belt (2)
7. Replace transmission belt (1)
(2)
8. Check all fastening elements
9. General lubrication (3)
10. Transmission oil replacement
(1st time) (2)
11. Transmission oil replacement
(following times) (2)
12. Hydraulic system oil change
(SAE 15W/40) on models
550D-1750D-50D (1st time) (2)
13. Hydraulic system oil change
(SAE 15W/40) on models
550D-1750D-50D (subsequent
times) (2)
1) At the first signs of malfunction, contact
your Dealer immediately.
2) This operation must be carried out by
your Dealer or an Authorised Service
Centre.
3) General lubrication should also be
carried out whenever the machine is to
be left unused for a long period.
Engine
See the engine manual for the full list and
frequency.
Change engine oil (also see paragraph below) -
Check and clean air filter - Replace air filter -
Check fuel filter - Replace fuel filter - Check and
clean spark plug points - Replace spark plug
I
25 hours
25 hours
GB
25 hours
F
25 hours
D
20-30 hours
25 hours
E
-- hours
25 hours
NL
25 hours
50 hours
P
500 hours
H
20 hours
SK
50 hours
CZ
RUS
UK
PL
FIN
BIH
SRB
HR
35