Publicité
IBM Confidential
Figure 128. Leader Block Assembly (LBA)
10. Continue rotating the loader motor worm gear
( 3
in Figure 127 on page 262) is positioned as shown. Notice that the rotator stub
on page 262) is nearly aligned with the cartridge loader tray guide bearing
262).
11. Remove the cartridge from the cartridge loader tray.
12. Go to "Ending procedure" on page 266.
Half height drive: No apparent failure or damage to tape
About this task
Note: If the cartridge in the drive is an INPUT tape that contains ACTIVE or 'ONLY COPY' data (there is no
backup), eject commands that are issued at the host fail to unload the tape, and power-cycling the drive
fails to eject the cartridge, make no further attempts to unload this tape. Call Technical Support and open
a PMR if one is not already open, to initiate the process of sending the drive with the loaded cartridge in
for recovery.
Procedure
1. Set the drive on its left side with the head and tape path facing up.
( 1
in Figure 127 on page 262) until the rotator stub
Appendix I. Manual cartridge removal procedure 263
( 3
in Figure 127
( 2
in Figure 127 on page
Publicité
