Publicité
Les langues disponibles
Les langues disponibles
M O U N T I N G
Y O U R W I N C H
Superwinch mounting (fitting) kits
are available for most popular vehi-
cles. If you can't locate a kit locally
contact Superwinch at the address
listed on the front of this manual
for the name of a Superwinch dealer
near you.
Detailed mounting instructions are
provided with each mounting kit.
Read and follow directions carefully
to ensure proper winch alignment
and trouble free operation.
This winch MUST
be mounted with
the wire rope in the underwind
direction. Improper mounting could
damage your winch and void your
warranty.
NOTES
1. All dimensions are in inches [millimeters].
2. Winch is mounted with M10 x 1.5 hardware. Typical mount is to flat surface capable of handling
the loads. Bolts to be ISO Grade 8.8 or better.
8
I N S T A L L A T I O N
MINIMUM ELECTRICAL
REQUIREMENTS
For 12 volt winches, a 60 ampere
alternator and battery with 440
cold-cranking amperes capacity are
the minimum recommended power
sources. If the winch is in heavy use,
an auxiliary battery and heavy duty
alternator with battery isolator are
recommended.
Step (1)
Install mounting kit or structural
support for winch.
Step (2)
Mount the winch to the mount that
you have designed.
The M10 x 1.5 x 40mm mounting
bolts supplied are the correct length
for use with up to a 1/4" (6.3mm)
thick plate.
I N S T A L L A T I O N
C O N T.
Motor
Solenoid
Assembly
Figure 10
Do not sub-
stitute any
strength grade weaker than ISO
grade 8.8.
When attaching wires to the motor
terminals and solenoids (relays),
hold the inner nut when tightening
the outer nut. Do not allow the
motor terminals to rotate for it may
cause internal wire breakage or
part misalignment. Be especially
careful in preventing the solenoid
(relay) terminals from rotating. Any
rotation can damage the solenoid
(see Figure 11).
Figure 11
Step (3)
Disconnect the vehicle battery
leads.
Remote
Switch
Receptacle
Green
Black
White
Red
Circuit Breaker
Black
Automobile bat-
teries contain
gasses which are flammable and
explosive. Wear eye protection dur-
ing installation and remove all
metal jewelry. Do not lean over bat-
tery while making connections.
Be Prepared
Figure 12
Step (4)
Route the two (2) wires through
the vehicle grille to the battery. To
ensure against insulation abrasion
and/or cutting, apply several layers
of electrical tape where wiring may
come in contact with sharp metal
parts of the vehicle. Attach the cir-
cuit breaker assembly to the end of
the red terminated wire. Wrap the
circuit breaker assembly with elec-
trical tape to prevent accidental
short circuits.
9
Publicité
