Getting Started - Sun Microsystems SunPCi 1.1 Guide D'installation

After the AnswerBook package is installed, you can view the documentation on the
screen and print selected pages.

Getting Started

To get started, you need to perform the following steps:
Install the Solaris patches
Install the SunPCi card
Install the SunPCi AnswerBook (Solaris 2.6 and Solaris 7) or view the HTML files
(Asian languages)
Install the SunPCi software
The sections that follow describe each of these steps in detail. Once you have
completed these steps, SunPCi will be ready for you to install Windows 95 or
Windows NT Workstation 4.0.
Note – Windows 3.x is not supported in this release of SunPCi.
Installing the Solaris Patches
You will need to install Solaris patches before you install the SunPCi hardware and
software. The patch that you install depends on your operating system version.
(Note that the CD-ROM may contain additional patches in addition to the ones
listed here.)
Solaris 7: patch 106541-01
Solaris 2.6: patch 105486-04
Solaris 2.5.1: 104560-05
To find out the version of your operating system, type the following command. Do
not type in the %; that is your system prompt. Press Return when you have finished
typing the command.
% uname -a
en-2 SunPCi 1.1 Installation Guide • September 1999