Finishing The Installation - Sun Microsystems SunPCi 1.1 Guide D'installation

Caution – The SunPCi card is designed to operate only with the RAM DIMMS
supplied by Sun. If you install a RAM DIMM not supplied by Sun, you will
invalidate the warranty for your SunPCi card.
4. Insert the SunPCi card into the PCI slot. Remember that if you are using the add-
on backplate, you will need to use two slots. Slide the tab on the bottom of the
panel (where the ports are located) into the clips at the bottom of the slot in the
back panel of your system.
Be careful not to dislodge any other cards that may be installed in other slots. Make
sure the ports face out through the back panel of the system, through the hole
created when you removed the filler panel. If you are using the add-on backplate,
make sure the ports on the backplate also face out through the back of your
workstation.
5. Tighten the screw on the SunPCi card to secure it in place.
Use the screw you removed from the filler panel.
6. If you are using the optional add-on backplate, tighten the screw to secure it in
place beside the SunPCi card.

Finishing the Installation

1. Remove the wrist strap from your wrist and the workstation.
2. Replace the cover or unit top, following the instructions appropriate to your
system.
Refer to the instructions included with your system.
3. Reconnect all cables to the back of the system.
Caution – Do not turn on the power to your system without replacing and securing
!
the system unit cover.
4. Press the power on/off switch to turn your system back on.
The system automatically reboots when you turn on the power to the system unit.
5. Turn on the power to your system peripherals.
6. Log in again, become superuser, and continue with the SunPCi software
installation instructions in the following section.
SunPCi Hardware and Software Installation en-11