Sun Microsystems SunPCi 1.1 Guide D'installation page 19

Your system should return information similar to the following:
PKGINST: SUNWspci
NAME: SunPCi
CATEGORY: system
ARCH: sparc
VERSION: 1.0
BASEDIR: /opt
VENDOR: Sun Microsystems, Inc.
DESC: This package contains the SunPCi software for Solaris
2, Sparc PCI Platforms
PSTAMP: quarklab17m04072332
INSTDATE: Jun 04 1999 07:47
HOTLINE: Please contact your local service provider
STATUS: completely installed
FILES:
30317 blocks used (approx)
Note the information in the VERSION: line. If VERSION is 1.0, then you have
SunPCi 1.0 installed.
Now that you know the version of SunPCi that you have installed, follow the
appropriate procedures to remove the old SunPCi package and the upgrade patch (if
any).
Removing the Patch (Solaris 2.5.1)
If you have a SunPCi upgrade patch installed and you are running Solaris 2.5.1,
follow this procedure to remove the patch. If you are running Solaris 2.6 or Solaris 7,
skip this section and proceed to "Removing the Patch (Solaris 2.6 and Solaris 7)" on
page en-17.
1. Open a command (terminal) window on the Solaris desktop.
440 installed pathnames
62 directories
15 executables
SunPCi Hardware and Software Installation en-15