Agilent Technologies Turbo-V 1000 HT Notice De Mode D'emploi page 295

Starting the Pump
If the forepump and vent device are not operated by the controller,
close the vent valve and switch on the forepump.
Before starting the pump the cooling mode must be selected.
NOTE
With the FRONT panel operation selected, the REMOTE and RS 232 operations
NOTE
are inoperative; conversely, the CYCLE NUMBER and PUMP CURRENT push-
buttons are always active, even when the operating mode selected is REMOTE
or RS 232 / 422 / 485.
S
Turbo-V 1000HT Controller User Manual / 87-900-894-01
Press the START push-button (or use the remote or RS 232 start
signal), and the display shows:
O F T
[ - -
S T A R T
- - - - -
(G)
Technical Information
Use
O N
- - - ]
295/310
17